| Specification |
| Brand | TRIPP LITE |
| Model | SMART1500RM2U |
| Output Volt Amp Capacity (VA) | 1500 |
| Output Watt Capacity (watts) | 1350 |
| Nominal Output Voltage(s) Supported | 120V |
| Frequency compatibility | 60 Hz |
| Output voltage regulation (line mode) | -21%, +8% |
| Output voltage regulation (Battery mode) | +/- 5% |
| Built-in UPS output receptacles | 8 5-15R outlet(s) |
| Built-in controllable switched load banks | Two switchable two-outlet 5-15R load banks |
| Output AC waveform (AC mode) | Sine wave |
| Output AC waveform (battery mode) | Pure Sine wave |
| Rated input current (at maximum load) | 12A |
| Nominal Input Voltage(s) Supported | 120V AC |
| UPS input connection type | 5-15P |
| Input circuit breaker | 15A |
| UPS Input cord length (ft.) | 10 |
| Phase | Single-Phase |
| Full load runtime (minutes) | 4.5 min. (1350w) |
| Half load runtime (minutes) | 13 min. (675w) |
| DC system voltage (VDC) | 36 |
| Battery recharge rate (included batteries) | Less than 4.5 hours from 10% to 90% |
| Replacement battery cartridge (internal UPS battery replacement) | RBC93-2U |
| Battery Access | Front panel battery access door |
| Battery replacement description | Hot-swappable, user replaceable batteries |
| Voltage regulation description | Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 147 |
| Front panel LCD display | Yes |
| Alarms | Audible alarm indicates UPS startup, power-failure, low-battery, overload, UPS fault and remote shutdown conditions |
| Alarm cancel operation | Power-fail alarm can be temporarily silenced using alarm-cancel switch; silent mode alarm configuration option available |
| Switches | 3 pushbutton switches control OFF / ON power status, MODE selection and MUTE / ENTER control functions |
| UPS AC suppression joule rating | 570 |
| UPS AC suppression response time | Instantaneous |
| EMI / RFI AC noise suppression | Yes |
| Installation form factors supported with included accessories | 4 post 19 inch rackmount |
| Primary form factor | Rackmount |
| UPS / Power Module dimensions in primary form factor | 3.5" x 17.5" x 13.45" (H x W x D) |
| Rack Height | 2U |
| UPS / Power Module weight | 46.5 lbs |
| Communications interface | USB; DB9 Serial; EPO (emergency power off); Slot for SNMP/Web interface |
| UPS Certifications | Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico); Meets FCC Part 15 Category B (EMI) |
| Warranty | 2 Years Manufacturer Warranty |
|
